Decal Install Tutorial

Clean & dry your surface you wish to apply - these decals work best on smooth surfaces.

Peel the back off slowly starting at the corner, and keeping the backing pressed down to force the vinyl to stay on the transfer tape. Keep backing!!

Keep going...make sure to get all the bubbles out! Be gentle though, not too fast. Slower with more pressure is better - you don't want to tear it!

Take a gift card (or squeegee) and firmly apply pressure & slowly wipe across the front at an angle to work out bubbles.

Once you have worked the vinyl off the backing, & have it on the transfer tape, delicately place it where you want...remember, once it goes down, it will not come back up!

After waiting about 5 minutes, come back and do one more firm pass. Then grab the top left corner, & peel back & pull down at an angle...SLOWLY!

Flip the decal over, and squeegee the back as well. Again, apply firm pressure as you wipe from corner to corner.

Now, squeegee like your life depended on it!  Be gentle though, not too fast. Slower with more pressure is better - you don't want to tear it!

After you've peeled off the transfer tape, grab the backing and put it shiny side facing you. Grab your card, and squeegee a couple more times. And you're done!

Please make sure to allow the vinyl 24 hours to cure before getting wet, going through car wash, etc. Please keep placement in mind of rear wipers on vehicles. Please do not apply to things that would go in a dishwasher. This is outdoor vinyl, and should last several years according to the manufacturer.